【单选题】
在聘期内发生本人原因造成的严重差错（含）以上的工作差错或发生___次（含）以上的一般差错者，将取消岗位教员资格。
A. 1
B. 2
C. 3
D. 4
查看试卷，进入试卷练习
微信扫一扫，开始刷题
答案
B
解析
暂无解析
相关试题
【单选题】
_____carpet maybe required for emergency landing. ___
A. Water
B. Foam
C. Rubber
D. Sand
【单选题】
Before providing radar service,air traffic controllers hould______to the aircraft. ___
A. confirm altitude
B. confirm identity
C. confirm speed
D. confirm heading
【单选题】
Because of their high fuel consumption at low levels,______prefer to remain at higher altitudes when they fly. ___
A. light and small aircraft
B. propeller aircraft
C. Jets
D. allaircraft
【单选题】
When an aircraft was in emergency after taking off,i tshould______before landing. ___
A. check the engine
B. read the checklist
C. dumpfuel
D. makeaplan
【单选题】
“Engine flamed out“means______.___
A. Engine failure
B. Engine fire
C. Engine started
D. Engine lost
【单选题】
The opposite meaning of“converging”is______.___
A. diverging
B. opposite
C. diverting
D. closing
【单选题】
Which of the following is not included in the ATC clearance? ___
A. Aircraft callsign
B. Flight route
C. Wind direction and speed
D. Clearance limit
【单选题】
“Recycle squawk A0612”means______.___
A. reselect squawk number A0612
B. don’t use A0612
C. who is squawking A0612
D. squawk A0612
【单选题】
“A575”is a name of a route.“A”means_________
A. the order
B. the first kind
C. main south and north direction
D. no special meaning
【单选题】
“FMC”is a system in an aircraft to manage the______.___
A. met message
B. flight data
C. flight pitch
D. flight roll
【单选题】
“Deteriorating weather”means the weather is getting______.___
A. better
B. clear
C. good
D. worse
【单选题】
Azimuth means horizontal______or direction. ___
A. heading
B. direction
C. bearing
D. scale
【单选题】
According to characters and conditions of flights on the route,ATS route is divided into______and______route. ___
A. domestic,international
B. fixed,temporary
C. regional,national
D. civil,military
【单选题】
Fuel______means the quantity of fuel carried by now. ___
A. reminding
B. endurance
C. number
D. total
【单选题】
The opposite meaning of“speedup”is_________
A. slowdown
B. speeddown
C. speedlow
D. slowby
【单选题】
Pilot turns on squawk______to request a squawk number. ___
A. 3000
B. 3500
C. 4000
D. 2000
【单选题】
First______assistance means doctor and ambulance in an emergency condition. ___
A. emergency
B. priority
C. aid
D. help
【单选题】
When somebody is reported hurt on board,maybe it will need______assistance on arrival. ___
A. fire-cart
B. medical
C. police
D. wheelchair
【单选题】
In emergency descent procedure,the pilot should turn right______out of the route while descending. ___
A. 40°
B. 30°
C. 20器
D. 15°
【单选题】
管制员在对空指挥过程中，越是繁忙的时候，语速应___
A. 保持平稳，避免频繁重复指令
B. 尽量快些，才能指挥更多飞机
C. 降低语速，避免口误
D. 时快时慢，引起机组的注意
【单选题】
According to ICAO,a standard holding pattern should all turn to the______.___
A. right
B. west
C. left
D. east
【单选题】
The standard altimeter setting is______inhpa. ___
A. 1013.20062
B. 1010.10062
C. 29.92002
D. 30.10002
【单选题】
2500f/m rate of vertical speed is equal to______.___
A. 10m/s
B. 15m/s
C. 20m/s
D. 25m/s
【单选题】
陆空通话时，什么时候推荐使用“IMMEDIATELY（立即）”这个词：___
A. 相对飞行穿高度时
B. 天气差时，担心自己会忘记某个正在改变高度的动态
C. 飞机多时，为了节省精力
D. 在紧急情况下，用于冲突解脱时
【单选题】
What is the best course of action for a pilot to follow when thunderstorms are observed along the route of flight? ___
A. Fly below the thunderstorms
B. Climb over the thunderstorms
C. Disregard the thunderstorms
D. Take any action to avoid all thunderstorms
【单选题】
Aeronautical chart is divided into two categories,______. ___
A. Aeronautical map and special type of aeronautical chart
B. En-route chart and approach chart
C. Area chart and standard instrument arrival and departure chart
D. Aerodrome chart and area chart
【单选题】
Aircraft are required to comply with ATC instructions within______.___
A. advisory airspace
B. domestic airspace
C. controlled airspace
D. international airspace
【单选题】
Amendments to the initial clearance will be issued at anytime an air traffic controller deems such action necessary to______.___
A. avoid possible confliction between aircraft
B. correct the previously issued clearance
C. cancel the flight plan
D. expedite the traffic
【单选题】
研究表明，当耳机话筒的位置距离嘴（ ）英寸且稍微偏下时，传输的声音质量最佳。（注：1英寸=2.54CM）___
A. 0.25-0.5
B. 0.75-1
C. 1.25-1.5
D. 1.75-2
【单选题】
“I want to divert to shanghai” is equal to______.___
A. I want to our destination Shanghai
B. I want to overfly Shanghai
C. I want to alternate to land at Shanghai
D. I want to call Shanghai control
【单选题】
When an aircraft is being subjected to unlawful interference, the pilot should try to notify _______ of this fact.___
A. the appropriate ATC units
B. company
C. the passengers on board
D. air attendants
【单选题】
When pilot say“Did you pick it upon your screen?”,that means______.___
A. did you pick up your screen?
B. did you see it on your screen?
C. did your screen pick me up?
D. did you change your radar?
【单选题】
ATC clearance does not contain______.___
A. clearance limit
B. altitude data
C. route of flight
D. flight direction
【单选题】
When pilot sets an altimeter setting to a QNH,that will indicate_________
A. flight level
B. altitude
C. height
D. safety level
【单选题】
When pilots set a pressure of 29.92 in mercury to indicate_________
A. altitude
B. height
C. flight level
D. safety level
推荐试题
【单选题】
为保证牛头刨床横梁的水平导轨和升降导轨相互垂直，应先将___刮削好，并以此为基准，用水平仪测量两组导轨之间的垂直度误差，然后按照该误差对导轨进行刮削。
A. 水平导轨和水平导轨背面
B. 升降导轨和升降导轨背面
C. 升降导轨和水平导轨的背面
D. 水平导轨和升降导轨背面
【单选题】
在轴组的装配中，常在轴两端的支承点上用轴承盖单向固定，分别限制轴组两个方向的轴向移动。但轴因受热伸长易使轴承卡主，为此采取的处理措施是___。
A. 在右端轴承外圆与端盖间留有0.5~1mm间隙
B. 给轴承加注足够多的润滑油
C. 轴承内圈与轴之间采用间隙配合
D. 采用高精度的轴承
【单选题】
手用铰刀用高速钢或高碳钢制成，直径从3~120mm，按铰刀的直径公差不同，没把标准直径铰刀都有三个号，即1号铰刀、2号铰刀、3号铰刀，关于铰刀的自身精度，下列选项中，哪个是正确的___。
A. 1号铰刀直径精度比3号高
B. 1号铰刀直径精度比3号低
C. 1号铰刀直径精度和3号一样
D. 两者无法对比
【单选题】
液压缸安装后要进行性能试验，下列关于液压缸性能试验说法错误的是___。
A. 检测活塞或油缸移动速度是否均匀
B. 检测活塞杆是否弯曲，弯曲会造成缸盖密封损坏，从而导致泄漏
C. 检测油封装置是否过紧，而使活塞或油缸移动时阻滞，或过送而造成漏油
D. 在规定压力下，观察活塞与油缸端盖、端盖与油缸的结合处是否有漏油
【单选题】
零件无损检验技术是指在不破坏产品的形状、结构和性能的情况下，为了了解产品及___
A. 各种结构物材料的内部结构所进行的各种检测
B. 各种结构物材料的性能及内部结构所进行的各种检测
C. 各种结构物材料的状态、性能及内部结构所进行的各种检测
D. 各种结构物材料的质量、状态、性能及内部结构所进行的各种检测
【单选题】
高速机械挠性转子的动平衡的平衡检测，是将转子驱动至一定的转速，通过对___的测量，以求知引气轴承动反力或转子动挠度的原始不平衡质量的大小和分布规律。
A. 轴承振动或转子动挠度
B. 机械振动或转子静挠度
C. 轴承弯曲或转子静挠度
D. 轴承弯曲或转子动挠度
【单选题】
装配不可分离型圆柱孔轴承(如深沟球轴承、调心球轴承、角接触轴承等)时，应___。
A. 把轴承同时压在轴上和壳体孔中
B. 应将轴承先压入壳体中
C. 先得轴承装在轴上，然后连同轴一起装入壳体中
D. 按座圆配合的松案程度决定其装配顺序
